Evolution-engines 62GXI User Manual download pdf (Page 6)

6

1. Use a 3mm ball-link to attach the throttle

linkage to the throttle arm on the throttle

body.

2. Power ON the transmitter and receiver. Move

the throttle stick and throttle trim to center.

3. Place the servo arm on the throttle servo so

the arm is perpendicular (90°) to the throttle

linkage.

4. Ensure the throttle servo is moving in the

appropriate direction. The throttle servo arm

should move towards the engine when the

throttle stick is moved to low throttle. If it

doesn’t, reverse the servo direction in your

transmitter. If you use servo reversing, you

will need to rebind your transmitter to the

receiver for failsafe to function properly.

5. Move the throttle stick to low throttle on the

transmitter. Reduce the throttle trim to its

lowest setting.

6. Move the linkage connected to the throttle

body to full-idle (forward). On the servo

arm, ﬁnd the hole that is closest to 16mm

(5/8 in) from the center of the arm. Mark the

pushrod where it meets this hole.

16mm

7. Using pliers, bend the pushrod so there is a

90° bend at the mark.

8. Using a pushrod keeper, secure the pushrod

in the servo arm.

9. Check that the throttle arm on the throttle

body can travel fully open and fully closed

(both have hard stops). Adjust your

transmitter endpoints to ensure full travel.

10. If there is a large difference between the

endpoints, adjust the endpoints and sub-

trim to ﬁnd a balance where the endpoints

are approximately within 10% of each

other.

Connecting the Throttle Linkage

Installing the Mufﬂer

The mufﬂer mounting accessory package

includes mounting screws (2), lock washers

(2), mufﬂer gaskets (2) and an L-wrench.

We suggest using high-temperature RTV as a

locking agent on the mufﬂer screws to keep

them tight.

1. Put a lock washer on each of the mufﬂer

screws. Push the mufﬂer screws through the

mufﬂer.

2. Place the mufﬂer gasket over the mufﬂer

mounting screws.

3. Align the mufﬂer gasket with the exhaust

opening and the mufﬂer mounting screws.

4. Tighten the mufﬂer screws.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments